Width of the cultivated strip, mm:  2620.

Weight: not more than 500 kg.

Blade width: 3360mm.

Height: 770 mm.

Working speed: not more than 40 km/h.

Working angle of rotation: 37 degrees.

Collision protection: mechanical floating suspension.

Longitudinal and transverse copying of the road slope.

Blade control from the driver's cab.

Blade type: rubber plowshare.

Blade lift/turn drive: hydraulic.

Width of the processed strip, mm:  2700 mm

Weight: not more than 1120kg.

Blade width: 3200mm.

Height: 1300mm.

Working speed: not more than 60 km/h.

Longitudinal and transverse copying of the road slope.

Blade control from the driver's cab.

Blade type: metal.

Blade lift/rotation drive is hydraulic.

Width of the processed strip, mm:  2600 mm

Weight: not more than 470 kg.

Blade width: 2780mm.

Height: 1080 mm.

Working speed: not more than 40 km/h.

Blade control from the driver's cab.

Blade type: Metal.

Blade lift/turn drive - hydraulic.

Width of the processed strip, mm:  2600 mm

Weight: not more than 1100kg.

Blade width: 3130mm.

Height: 1220 mm.

Working speed: not more than 40 km/h.

Blade control from the driver's cab.

Blade type: metal.

Blade lift/turn drive is hydraulic.

ЩО-10 is installed in the interbase space. In summer, the sweeping brush is used to sweep debris from the roadway, in winter – for patrol snow removal. The advantage of this equipment over the classic chain design is the presence of a hydraulic drive, which gives:

A more reliable attachment to the chassis of the car, independent of the binding to the gearbox;

Easy operation and maintenance of the drive (if necessary, maintenance or replacement is possible

the hydraulic motor does not require a special tool);

The drive of the brush equipment is made from the hydraulic system of the equipment;

Hydromechanism that eliminates vibration of the brush during operation;

The ability to adjust the clamping force of the brush from the driver's cabin;

Adjusting the brush contact with the ground using a hydraulic cylinder;

The presence of a mechanism for adjusting the height of the brush relative to the roadway, eliminating uneven wear of the pile

The brush drive mechanism is protected from overloads.

The total width of the brush on the pile, m is not less than 2.84,

The width of the processed strip is maximum, m at least 2.5,

Pile diameter: 550 mm

Pile material: polypropylene.

Weight: 150 kg

The distance from the road surface to the brush in transport position: 160 mm.

Rotation speed, rpm at least 470.

Operating speed, km/h, no more than 40.

The angle of rotation of the brush, deg. at least 30.

Lifting and lowering using a two–way hydraulic cylinder.

The exclusion of debris and aggressive materials from entering the power units of the car is ensured.

Hydraulic oil cooling system:

is provided by an additional radiator.