Garbage trucks with a side loading body, the body design is frameless for MK-x552- and framed design - for MK-x551-xx. Coefficient of compaction is up to 2,5.

Simplicity of design and maintenance, reliability in operation - the main feature of these garbage trucks.

The body of the trucks is made of high-quality structural low-alloy steel 09G2S, due to which its construction is lightened without the loss of strength. In the front part of the body there is a press chamber with a pressing plate of a  bulldozer classical pressing mechanism (specific compression compacting pressure about 0,2 MPa) moving along the central guide. In the upper part of the plate there is a swivel waste leveler, and in the lower part there is a central joint for fixing the hydraulic cylinders of the drive.

The bodies of the hydraulic cylinders are angled to each other. From above, the press chamber is closed with a lid. The lid is opened by the hydraulic lift cylinder simultaneously with extension of the outrigger under the manipulator, if available. The rear part of the hopper is hinged with a semicircular shaped tailgate with increased capacity (up to 0.9 m3), which is opened by hydraulic cylinders.

In the transport position the tailgate is pressed against the hopper on an inclined surface (to improve body tightness) and locked with clips. In the lower part of the tailgate there is a P-shaped rubber seal, which provides sealing of the body due to tight adhesion of the tailgate to the body. When compacting the wastes, some moisture is released, the tightness of the body is ensured by the height of the rubber seal of the tailgate (300 mm).

The body is pivotally hinged to the subframe. The body has a base made of channels, by which it rests on the subframe. The waste is unloaded by a dumping method. The body lifting mechanism is driven by single-acting hydraulic cylinders.

To reload the waste from containers the manipulator with the load-carrying capacity of 700 kg is used, which is characterized by simplicity and high durability. It is also made of high-quality structural low-alloy steel 09G2S. The manipulator is pivotally mounted on the subframe on the right side of the garbage truck. It consists of a frame, boom, extendable carriage, tipper and gripper. As standard, the manipulator is equipped with one of three types of grippers for the front wall of the container.

On request, the manipulator can be completed with additional grippers (patent of 'Ryazhsky Avtoremontniy Zavod' JSC № 160217 - universal replaceable gripper MK 14.900.000 for standard containers with capacity of 80, 120, 140, 240, 240, 360, 460, 460, 660, 1100, 1300 liters and box-shaped metal containers with capacity from 700 to 1100 liters (standards of the containers to be picked up depend on the type of the installed gripper). In the transport position of the manipulator, the container gripper should be rotated to the maximum angle until it comes into contact with the wall of the press chamber.

The hydraulic system is of single-circuit type HDC (Heavy Duty Components) with manual hydraulic distributors to control the actuating hydraulic cylinders, consists of high quality Walvoil Danfoss components manufactured in Italy. Fittings are produced by ‘Cast’. Rods and pipes of ‘Cromsteel’ hydraulic cylinders, Romania. Seals of rods and pistons, rings, mud collectors of ‘Busak-Shamban’ hydraulic cylinders. ‘STAUFF’ hydraulic tubes.

Painting with two-component acrylic-urethane materials. It is possible to paint the equipment in the color of the customer's company.