Garbage trucks with side loading of the body, frameless body design for MK-x552- and frame design for MK-x551-xx.  Pressing coefficient is up to 2.5.

Simplicity of design and maintenance, reliability in operation are the main features of these garbage trucks.

The truck body is made of high-quality structural low-alloy steel 09G2S, which facilitates its construction without the loss of strength. In the front part of the body there is a press-chamber with a pressing plate of a bulldozer classic pressing mechanism (specific compression compacting pressure about 0.2 Mpa), moving along the central guide.

In the upper part of the plate there is a swivel waste leveler, and in the lower part there is a central hinge for fixing the hydraulic cylinders of the drive. The hydraulic cylinder housings are positioned at an angle to each other. The top of the press-chamber is closed with a lid. The lid is opened by a hydraulic lifting cylinder simultaneously with the extension of the outrigger under the manipulator, if available. A semicircular tailboard with an increased capacity (up to 0.9 m3) is pivotally fixed to the rear part of the hopper, which is opened with hydraulic cylinders.

In the transport position, the tailboard is pressed against the drive along inclined surface (to improve the tightness of the body) and locked with clamps. A P-shaped rubber seal is fixed in the lower part of the rear side which ensures the sealing of the body due to the tight fit of the rear side to the body. When compacting wastes, some moisture is released, the tightness of the body is ensured by the height of the rubber seal of the rear side (300 mm).

The body is pivotally mounted on the subframe. The body has a base of channels, which rests on the subframe. The waste is discharged in a dumping way. The drive of the body lifting mechanism is provided by single-acting hydraulic cylinders.

To reload the waste from containers, a manipulator with a load-carrying capacity of 700 kg is used, and characterized by simplicity and high durability. It is also made of high-quality structural low-alloy steel 09G2C. The manipulator is mounted pivotally on the stretcher on the right side of the garbage truck. It consists of a frame, boom, retractable carriage, tipper and gripper. As standard, the manipulator is equipped with one of three types of grips for the front wall of the container.

On request, the manipulator can be equipped with additional grips (patent of ‘Ryazhsky Avtoremontniy Zavod’ JSC No. 160217 - universal replaceable grip MK 14.900.000 for standard containers with capacity of 80, 120, 140, 240, 360, 460, 660, 1100, 1300 litres and box-shaped metal containers with capacity from 700 to 1100 litres (standards for pick-up containers depend on the type of the grip installed). In the transport position of the manipulator, the container grip must be rotated to the maximum angle until it can come into contact with the wall of the press-chamber.

The single-circuit hydraulic system of  HDC type (Heavy Duty Components) with manual hydraulic distributors for controlling executive hydraulic cylinders consists of high-quality Walvoil Danfoss components manufactured in Italy.  Fittings are produced by ‘Cast’. Rods and pipes of ‘Cromsteel’ hydraulic cylinders, Romania. Seals of rods and pistons, rings, mud collectors of ‘Busak-Shamban’ hydraulic cylinders. ‘STAUFF’ hydraulic tubes.

Painting with two-component acrylic-urethane materials. It is possible to paint the equipment in the color of the customer's company.